PTFE TUBE SEALED CAP FOR 3D PRINTING FILAMENT @MirageC

Uploaded November 2018 | Updated September 2026, 1 week ago

Small design I made to avoid opening the filament dry box in order to feed the filament out of the tube for printing. With this solution, the box can remain closed and sealed for the life of the spool. No matter how many times you swap filament.

Thingiverse page:
thingiverse.com/thing:3196567/edit

PTFE TUBE SEALED CAP FOR 3D PRINTING FILAMENT

COMPLEX Parts are no issue if you know your SUPPORTS

Printing Benchy with SERVO motors on my HevORT

Fibers will make all material sensitive to water - see link in the descriprion for entire video

HevORT CoreXY Filament Sensor and Jam detector

ChORT - Printable Credit Card Holder Wallet

Printing at 800 mm/s on a FDM CoreXY - Can the HevORT do it?

Exploding Detailed View with Fusion360 - Quick Tip

3D Printer - Electronic Islands - Electronics Layout

Triple motor Z axis on MGN rails CoreXY - HevORT - Advanced DIY 3D printer

3D printer on Servo Motors? HevORT & ClearPath testing spoiler