Uploaded December 2019 | Updated November 2026, 3 hours ago
A step by step guide to programming the sweep function on a Feeltech FY2300 function generator, the twenty megahertz unit supplied in the RPX 2.0 combo kit. Aaron Murakami works through the interface button by button: selecting frequency, amplitude, offset or duty cycle as the object, setting start and end frequencies digit by digit, setting the sweep time, and choosing linear rather than logarithmic progression. The setting he flags as important is amplitude: the input is marked 2.1 volts maximum and should not be exceeded, because a small class A stage boosts the signal before it is mixed with the carrier and fed to the RF amplifier. He explains the trade-off between a fast sweep that revisits each frequency often and a slow one that dwells on each longer, and finishes by saving the setting to a memory slot.
Chapters
0:00 What this unit is and how it connects
1:21 Selecting the object to change
2:37 Setting the start frequency
5:11 Setting the end frequency
6:26 Sweep time, and the minimum
7:48 Linear against logarithmic
10:23 Amplitude, and the 2.1 volt limit
12:20 Offset and duty cycle
emediapress.com/rpx3
emediapress.com
emediapress.com/energytimes
Posted 2019-12-03.
A step by step guide to programming the sweep function on a Feeltech FY2300 function generator, the twenty megahertz unit supplied in the RPX 2.0 combo kit. Aaron Murakami works through the interface button by button: selecting frequency, amplitude, offset or duty cycle as the object, setting start and end frequencies digit by digit, setting the sweep time, and choosing linear rather than logarithmic progression. The setting he flags as important is amplitude: the input is marked 2.1 volts maximum and should not be exceeded, because a small class A stage boosts the signal before it is mixed with the carrier and fed to the RF amplifier. He explains the trade-off between a fast sweep that revisits each frequency often and a slow one that dwells on each longer, and finishes by saving the setting to a memory slot.
Chapters
0:00 What this unit is and how it connects
1:21 Selecting the object to change
2:37 Setting the start frequency
5:11 Setting the end frequency
6:26 Sweep time, and the minimum
7:48 Linear against logarithmic
10:23 Amplitude, and the 2.1 volt limit
12:20 Offset and duty cycle
emediapress.com/rpx3
emediapress.com
emediapress.com/energytimes
Posted 2019-12-03.










