Uploaded June 2017 | Updated September 2026, 20 hours ago

---

I had random stops in same print for two times and some weird movements as well on other prints. I tried everything possible including reinstalling CURA, flashing software... Last unchecked thing was SD card and BINGO! Bad Blocks in card! I Use write and read test in hard disk sentinel software. Later on I found 4 bad SD cards of 8 SD cards. 50% failure rate I was blow away!

GearBest --- goo.gl/pqKf6h
Banggood --- goo.gl/9CpYMJ
Aliexpress --- goo.gl/C8ndaT
Amazon --- goo.gl/amhHWX
Ebay --- goo.gl/VXLdte

3D printers parts and supplies goo.gl/NXVL7M

Cheap filaments
PLA filament goo.gl/D9jY9v
ABS Filament goo.gl/DBL1ok
Flexible filament -- goo.gl/1DMTJf

Premium/special quality filaments
APRINTAPRO shop goo.gl/sgXkAW

PrintaFix adhesion SPRAY goo.gl/Fr9tmU

Heat bed mosfet module -- goo.gl/91i7bQ

3D printing surface:
Sticker: goo.gl/WTmmiM
Glass: goo.gl/3GqP6Z
BueTape: goo.gl/7vQMYp

Switch for PSU goo.gl/sKzzkg

Rubber Timing Belt goo.gl/3xtQPv

SCS8UU-8mm-Linear-Ball-Bearing goo.gl/88pgGV



Please like and subscribe to my channel to help me making more videos.
Thank you so much for your support.
Best Regards
Nexi