Uploaded December 2025 | Updated November 2026, 5 hours ago
Carbonating your home brew is essential for the most part. There are exceptions like wine but other kinds of home brew need carbonation to give it fizz and balance the sweetness. Therefore getting carbonation right is essential.
Carbonating is not a matter of just adding sugar to your brew to ferment. This doesn’t work. Too little sugar and you just get very little carbonation leading to flat beer. Too much and you make an IED from a bottle or gushing beer. It a goldilocks scenario where you need to use just the right amount.
There are a number of sugar options for carbonating. You can use table sugar or sucrose. You can use pure glucose. There is corn sugar. Finally there is dry malt extract.
To get the right amount of sugar you need to do some maths. Thankfully the calculation is easy.
Table sugar
4.9 * litres = total sucrose in grams
Dry malt extract
7.5 * litres = total DME in grams
Corn sugar or dextrose
5.6 * litres = total dextrose in grams
You combine the required weight of sugar with a small amount of water. Add this to your fermenter or secondary. Decant this into your bottles, seal the bottles, and wait.
The waiting time will vary based on the yeast activity of your fermentation. More active yeast leads to much more carbonation in less time meaning your bottles are ready sooner. Less active means it takes much longer to carbonate your bottles.
It is important to remember that pressure rated bottles are necessary. Not suggested. Not optional. Necessary. If you don’t use pressure rated bottles they will explode.
While we have given a general calculation you should know that not all styles need the same level of carbonation. Belgian triple needs much more carbonation than an American IPA.
Carbonating your home brew is essential for the most part. There are exceptions like wine but other kinds of home brew need carbonation to give it fizz and balance the sweetness. Therefore getting carbonation right is essential.
Carbonating is not a matter of just adding sugar to your brew to ferment. This doesn’t work. Too little sugar and you just get very little carbonation leading to flat beer. Too much and you make an IED from a bottle or gushing beer. It a goldilocks scenario where you need to use just the right amount.
There are a number of sugar options for carbonating. You can use table sugar or sucrose. You can use pure glucose. There is corn sugar. Finally there is dry malt extract.
To get the right amount of sugar you need to do some maths. Thankfully the calculation is easy.
Table sugar
4.9 * litres = total sucrose in grams
Dry malt extract
7.5 * litres = total DME in grams
Corn sugar or dextrose
5.6 * litres = total dextrose in grams
You combine the required weight of sugar with a small amount of water. Add this to your fermenter or secondary. Decant this into your bottles, seal the bottles, and wait.
The waiting time will vary based on the yeast activity of your fermentation. More active yeast leads to much more carbonation in less time meaning your bottles are ready sooner. Less active means it takes much longer to carbonate your bottles.
It is important to remember that pressure rated bottles are necessary. Not suggested. Not optional. Necessary. If you don’t use pressure rated bottles they will explode.
While we have given a general calculation you should know that not all styles need the same level of carbonation. Belgian triple needs much more carbonation than an American IPA.










