weldingtipsandtricks | PrimeWeld MIG 180 Wire Speed Settings @weldingtipsandtricks | Uploaded 1 year ago | Updated 3 days ago
weldmongerstore.com/collections/weldmonger-top-20-products
Another Mig Welding video using 115 volt on a 20 amp circuit.
The primeweld mig180 has a good settings chart inside the wire feeder door.
Settings for 1/8" thick steel were listed at 18 volts and 236 inches per minute with .035" er70s6 wire and C25 gas (75 argon 25 co2).
What happens when you lower wire speed too much?
and what happens when your wire speed is too high for a given voltage?
WIre speed controls amperage but you also need adequate voltage in order to have an efficient arc.
Join the discussion with thousands of welders at the Welding Tips & Tricks forum
http://forum.weldingtipsandtricks.com
weldmongerstore.com/collections/weldmonger-top-20-products
Another Mig Welding video using 115 volt on a 20 amp circuit.
The primeweld mig180 has a good settings chart inside the wire feeder door.
Settings for 1/8" thick steel were listed at 18 volts and 236 inches per minute with .035" er70s6 wire and C25 gas (75 argon 25 co2).
What happens when you lower wire speed too much?
and what happens when your wire speed is too high for a given voltage?
WIre speed controls amperage but you also need adequate voltage in order to have an efficient arc.
Join the discussion with thousands of welders at the Welding Tips & Tricks forum
http://forum.weldingtipsandtricks.com