Uploaded May 2020 | Updated November 2026, 2 hours ago
You can use a full wave or full bridge rectifier (commonly shown as a diamond-pattern of four diodes) to flip the negative part of a signal into the positive region, but just like a half wave rectifier, the diodes will chop off the part of the signal near zero and thus cause distortion or incorrect readings. Using op amps to drive the diodes, however, in effect creates perfect diodes with no drops but still behaving like diodes, moving the diode clipping to the rails instead of inside the signal, so as long as the signal does not approach the rails, the full wave will be rectified with effectively no distortion.
Signal Processing and Filtering Playlist: youtube.com/playlist?list=PLoNmuzhZIVoqET_5MEGLc1_VAiTXpyZHw
You can join me on Discord as well! -- discord.gg/Rnvpscg
You can use a full wave or full bridge rectifier (commonly shown as a diamond-pattern of four diodes) to flip the negative part of a signal into the positive region, but just like a half wave rectifier, the diodes will chop off the part of the signal near zero and thus cause distortion or incorrect readings. Using op amps to drive the diodes, however, in effect creates perfect diodes with no drops but still behaving like diodes, moving the diode clipping to the rails instead of inside the signal, so as long as the signal does not approach the rails, the full wave will be rectified with effectively no distortion.
Signal Processing and Filtering Playlist: youtube.com/playlist?list=PLoNmuzhZIVoqET_5MEGLc1_VAiTXpyZHw
You can join me on Discord as well! -- discord.gg/Rnvpscg










