Uploaded December 2025 | Updated November 2026, 1 hour ago
Another test print for GHD mounts.
This time the filament has been in the dryer at 70 degs C for the best part of 18 hours, infill was bumped up to 100% and support speed was upped to 250mm/s.
I still need a razor blade to remove the supports.
Any suggestions regarding support options in the slicer would be gratefully received. Currently I am just using the default options except the support speed which made no difference.
Another test print for GHD mounts.
This time the filament has been in the dryer at 70 degs C for the best part of 18 hours, infill was bumped up to 100% and support speed was upped to 250mm/s.
I still need a razor blade to remove the supports.
Any suggestions regarding support options in the slicer would be gratefully received. Currently I am just using the default options except the support speed which made no difference.










