Uploaded March 2021 | Updated September 2026, 3 weeks ago
After twenty years I finally decided to build my power chamfering tool. Its probably good that I waited until there were better cordless options than the original pneumatic die grinder I was planning on using for this project. This tool is used to break the thousands of edges you have to deburr in the course of normal shop work. You can pass small parts through the vee block or the entire tool can be slid along the edge you want to chamfer. Plans will be available shortly after I clean up the chicken sketches.
After twenty years I finally decided to build my power chamfering tool. Its probably good that I waited until there were better cordless options than the original pneumatic die grinder I was planning on using for this project. This tool is used to break the thousands of edges you have to deburr in the course of normal shop work. You can pass small parts through the vee block or the entire tool can be slid along the edge you want to chamfer. Plans will be available shortly after I clean up the chicken sketches.
