Uploaded September 2026 | Updated November 2026, 3 hours ago
This was a fun design project! I've taken the parts I like from the commercial and 3D printable versions, as well as working within the limits of a 256mm build plate and my irrational hatred of removing supports, and this was what I ended up with.
The tool to tighten the 3D printed nut on the base is also 3D printed, so you don't need any other parts to put this together.
It's designed for 10mm pins at 148mm and 254mm, as those were the most requested sizes.
You can get it at makerworld.com/en/@oldforgecreate/upload
#pottery #3dprintedtool #potterytools
---
Support the creation of more videos on Patreon: patreon.com/oldforgecreations
For examples of my work that's been glazed, check out my Instagram:
instagram.com/oldforgecreations
Buy my work, or read more on my blog:
oldforgecreations.co.uk
Link to tools: oldforgecreations.co.uk/recommended-tools
This was a fun design project! I've taken the parts I like from the commercial and 3D printable versions, as well as working within the limits of a 256mm build plate and my irrational hatred of removing supports, and this was what I ended up with.
The tool to tighten the 3D printed nut on the base is also 3D printed, so you don't need any other parts to put this together.
It's designed for 10mm pins at 148mm and 254mm, as those were the most requested sizes.
You can get it at makerworld.com/en/@oldforgecreate/upload
#pottery #3dprintedtool #potterytools
---
Support the creation of more videos on Patreon: patreon.com/oldforgecreations
For examples of my work that's been glazed, check out my Instagram:
instagram.com/oldforgecreations
Buy my work, or read more on my blog:
oldforgecreations.co.uk
Link to tools: oldforgecreations.co.uk/recommended-tools










