Positioning Gantry Standoff in the center of Gantry Tube #plasmaCNC #diy @UDoIt2
Positioning Gantry Standoff in the center of Gantry Tube #plasmaCNC #diy @UDoIt2
Uploaded April 2025 | Updated September 2026, 3 weeks ago
The instructions requires the Gantry Standoff to be welded to the gantry tube. I positioned the standoff directly in the center using my calipers' edge gauge. Once positioned I clamp it down with my 8-inch C-Clamp.

Video Credits:
Video Production: U Do It™️ Studios a Division of No Cheese Records LLC All Rights Reserved. No Cheese Records® is a Registered Trademark of No Cheese Records LLC All Rights Reserved.

#welding #plasmacutter
Positioning Gantry Standoff in the center of Gantry Tube #plasmaCNC #diyOutlet loses power when I plug something into itWe take our phones for granted ... Look at what I can do!GOYOJO GW192S SuperIR Thermal Imaging Camera ReviewUsing a telescoping plank and trestles for working on my shed roofSmartphone adds an extra level of accuracy to machining #smartphoneUDoIt Video Gear - The best camera angle for maximum impactDesigning in Fusion 360 an End Cap for a Vinyl Railing and 3D Printing It - Episode 2Using the common reference point for all measurements #plasmacutterVIVOHOME Welding Cart???Battery powered chainsaw gives you flexibility without gasDrilling out the other holes marked by transfer punches
U Do It |

Positioning Gantry Standoff in the center of Gantry Tube #plasmaCNC #diy

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER