Uploaded April 2022 | Updated November 2026, 3 hours ago
So for the past couple of weeks I have been working on getting my CNC plasma table back up and running. It was stored in my father's warehouse about 120 miles away, so it was a bit of a process to get it home. Before it went into storage, the plasma cutter had been stolen, so all of that had to be replaced. I completely cleaned out the water table both top and bottom, and replaced the slats. After a couple of grueling weeks, it is running like new again. So for the first cut I decided to make my wife a little Yorkie Terrier wall art piece.
So for the past couple of weeks I have been working on getting my CNC plasma table back up and running. It was stored in my father's warehouse about 120 miles away, so it was a bit of a process to get it home. Before it went into storage, the plasma cutter had been stolen, so all of that had to be replaced. I completely cleaned out the water table both top and bottom, and replaced the slats. After a couple of grueling weeks, it is running like new again. So for the first cut I decided to make my wife a little Yorkie Terrier wall art piece.










