Pinstripe Thoughts and Jointer Blade Sharpening @GregsGarage
Pinstripe Thoughts and Jointer Blade Sharpening  @GregsGarage
Uploaded March 2014 | Updated November 2026, 3 hours ago
I cut down my Mack Sword 20 Series brush and now I can actually control it MUCH better. I am ready to get back onto the guitar project. Next step is running the necks over the jointer to straighten them out, so I sharpened the blades and leveled them up with the outfeed table.
Pinstripe Thoughts and Jointer Blade SharpeningPlumbing The Air Compressor With 1/2 Inch Galvanized Steel PipeGuitar Build - Part 19 - Winding the Custom Guitar PickupCool Cars From Greaserama 20151969 Rambler American - Done!Modeling a Socket Adapter- DPT BOX - FUSION 360 CADPorsche 356 Restoration - Passenger Door RepairsStretching & Embossing LeatherA Tormach Almost Killed MeGuitar Build 12 - Tapering the NeckPoleBarn - Episode 4 - Roof TrussesCam Position Sensor Replacement - Nissan Murano 3.5L
Gregs Garage |

Pinstripe Thoughts and Jointer Blade Sharpening

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER