Uploaded June 2023 | Updated September 2026, 1 day ago
See full pick and gut here ☕ https://m.
youtube.com/watch?v=Dfc_GlAojGA
Retep Reyem
|
Picking lever locks with wire ☕
🔇 TAP TO UNMUTE
![[L129] Tann Detector Pick, Gut and Reassemble](https://i.ytimg.com/vi/S0tQzZry7G4/mqdefault.jpg "[L129] Tann Detector Pick, Gut and Reassemble
This example of Tann detector had 5 tapered levers and the detector lever. The detector really only comes into play if you try to lift non binding low lifts in my experience. Otherwise when you lift a lever it normally will get caught on the fence at max travel if it is binding. Thanks for stopping by and cheers
00:00 Lock Operation
00:56 Picking starts
01:55 Reset and starting again
03:37 Picked
5:09 Gutting starts
08:07 Gutted
09:34 Reassembly starts (I guess) lol
13:22 Assembled and functioning Thanks for watching and cheers
#lockpicking #locksport #lpu")
![[L125] iNAHO little 3 row Picked](https://i.ytimg.com/vi/SfnQHnLLZFE/mqdefault.jpg "[L125] iNAHO little 3 row Picked
This example of iNAHO has 9 pins in 3 rows. Some 0 lifts pose a challenge to the unaware. Over all a fun pick and I think a good stepping stone into more rows and higher pin counts.
00:00 Lock Operation
00:37 Picking starts
01:18 Picked
01:36 Locking back up and checking operation
01:46 Lock and tool talk. Thanks and cheers
#lockpicking #locksport #lpu")
![[L133] Mul-T-Lock 7x7 Pick, Gut, and Reassemble](https://i.ytimg.com/vi/T9wqgsmlFws/mqdefault.jpg "[L133] Mul-T-Lock 7x7 Pick, Gut, and Reassemble
This is an older example of Mul-T-Locks 7x7. Had a few spools, overall nothing extreme. Cheers thanks for watching
00:00 Lock Operation
00:21 Picking Starts
01:12 Picked
02:47 Gutting starts
05:32 Gutted and some internals
06:12 Repining Starts
09:22 Assembled and checking operation
10:01 Tools, talk, and thanks
#lockpicking #locksport #lpu")
![[L137] Keso 2000s Picked](https://i.ytimg.com/vi/TgtlY9UJ35Y/mqdefault.jpg "[L137] Keso 2000s Picked
My just about out of box pick of keso 2000s. This example has 15 pins in 3 rows of 5 and they are really sharp spools. I did a lot of ping pong to get this first open. I have picked a few more times and my average open time is still 20 min. Lot more fight then I was expecting. Thanks for watching and cheers.
00:00 Lock Operation
00:19 Key reading
02:11 Picking starts
20:00 Is this a ping pong video it feels like it. lol
32:39 Open yay
33:48 Lets try and look inside and ramble lol
#lockpicking #locksport #lpu")
![[L146] Bricard Chifral Picked](https://i.ytimg.com/vi/UK_dT7NiM14/mqdefault.jpg "[L146] Bricard Chifral Picked
Bricard Chifral in this example has 15 pins in 3 rows. 2 pins are interactive. A nice mix of T pins and tapered divers make this a tricky pick. Shout out to Yabende Locksport for sending me some locks. Here is his video to show the internals and watch an amazing picker, pick the same lock. Cheers and thanks for watching
Yabende Locksport video https://www.youtube.com/watch?v=Kms6zuwkajU
00:00 Lock Operation
00:37 Picking starts
06:28 Open
07:25 Looking down keyway (I should get some fiber)
07:41 Locking it back up checking key operation
08:16 Biting and tool talk
12:56 Thanks and cheers")
![[L163] U-Shin Showa thin spools Picked and Gutted](https://i.ytimg.com/vi/VQETMtDo6FE/mqdefault.jpg "[L163] U-Shin Showa thin spools Picked and Gutted
This example of U-Shin Showa has 6 pins. The Driver pins are deep and thing lipped. Key pins have spooled section for over set trap. Keyway was slightly tricky, and has holes in right side warding to use. Cheers and thanks for watching
00:00 Lock Operation
00:20 Picking
01:34 Picked
03:00 Gutting starts
06:30 Gutted
07:30 Looking at pins ect
09:35 Tools and rambling
10:20 Close up Thanks and cheers
#lockpicking #locksport #lpu")
