Peanuts and Single malt 6 Tailstock new Shaft @BruceWhitham
Peanuts and Single malt 6 Tailstock new Shaft @BruceWhitham
Uploaded June 2018 | Updated September 2026, 2 weeks ago
I'm showing the machining of a new shaft for a tailstock for Troy's lathe. Troy had an exchange tailstock shaft that after my investigation proved to be too short so I have began the process of making him a new one. Like I did for Ray Caniglia 2 years ago.
Peanuts and Single malt 6 Tailstock new Shaft465 Quick Fix for a Fixture for small run of non circular flange machining.466 Nissan GTR How I repair the Engine Camshaft Stripped Bearing threadsPeanuts and Single Malt #4 Jigs and Tooling in my shop2019 has started with a lot on the plate for Gemtrek.Peanuts and Single Malt #1 Bruce Whitham in the shop random lots of projectsTRU-LINE-8- Rong Fu round column gear raise and lower Tips and ordering detailsFreds Pasta Strainer Take 3Getter out 20 part 2 removing plug and broken ezi outWhats in my box that Stan sent: PreludeSwing Arm Build, BarZ Summer Bash Getter Out Cap sale Limited EditionRestoration of a basket case Blown Motor
Bruce Whitham (Gemtrek) |

Peanuts and Single malt 6 Tailstock new Shaft

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER