Uploaded March 2024 | Updated November 2026, 2 hours ago
This is a recording I made last year of early experimentations with my Behringer system 55, (moog modular clone). Its just a easy listing piece of music like what you would hear back in the 60's and early 70's with some of the moog experimentation demo albums featuring the moog synthesizer.
The Patch:
This is a 4 part patch setup using two extra modules.
1.The sequencer is ran to the 921 VCO throug the sequential controller and audio is routed to the voltage controlled high pass filter with a LFO sweep from a Doepfer LFO
2. I have a Leaf Audio VCO connected to the lower Duophonic CV KB voltage and then it is routed through a Doepfer VCF with a Doepfer EG triggered from one step of the sequencer. the Doepfer VCF is getting a partial sequence before EG goes back to zero.
3. I have one set of 3 921B VCOs through one 921A driver, ( Output of VCOs is a 50% duty cycle square waveform) connected to the low Duophonic KB voltage as well. Audio is summed into the 904A Low Pass Filter with is own EG and VCA output,
4. I have another set of 921B VCOs through a second 921A driver connected to the upper duophonic KB CV. Here I am using slow pulse width modulation sweeps from the same Doepfer LFO used earlier for high pass filter. I have audio summed up and routed into the fixed filter bank and using the harmonics from the pulse width to make the fixed filter bank have some movement. this section had its own VCA and EG as well so each section is like its own little synthesizer.
I ran audio independently to different channels of the mixer and panned them a bit.
Hope you enjoy and thanks for listening!
Sincerely,
Jareth
This is a recording I made last year of early experimentations with my Behringer system 55, (moog modular clone). Its just a easy listing piece of music like what you would hear back in the 60's and early 70's with some of the moog experimentation demo albums featuring the moog synthesizer.
The Patch:
This is a 4 part patch setup using two extra modules.
1.The sequencer is ran to the 921 VCO throug the sequential controller and audio is routed to the voltage controlled high pass filter with a LFO sweep from a Doepfer LFO
2. I have a Leaf Audio VCO connected to the lower Duophonic CV KB voltage and then it is routed through a Doepfer VCF with a Doepfer EG triggered from one step of the sequencer. the Doepfer VCF is getting a partial sequence before EG goes back to zero.
3. I have one set of 3 921B VCOs through one 921A driver, ( Output of VCOs is a 50% duty cycle square waveform) connected to the low Duophonic KB voltage as well. Audio is summed into the 904A Low Pass Filter with is own EG and VCA output,
4. I have another set of 921B VCOs through a second 921A driver connected to the upper duophonic KB CV. Here I am using slow pulse width modulation sweeps from the same Doepfer LFO used earlier for high pass filter. I have audio summed up and routed into the fixed filter bank and using the harmonics from the pulse width to make the fixed filter bank have some movement. this section had its own VCA and EG as well so each section is like its own little synthesizer.
I ran audio independently to different channels of the mixer and panned them a bit.
Hope you enjoy and thanks for listening!
Sincerely,
Jareth










