Uploaded November 2019 | Updated September 2026, 2 weeks ago
Final test run of the repaired Ten Tec Omni 6 Plus for 24 hours . I said "Microprocessor board" no that was wrong it was the PLL (Phase locked loop ) Board that was the only board I worked on . After doing this repair I am of the opinion that the PLL board in this one went through the wave soldering machine to fast the solder coated the connecting pins on the little transformers but did not actually bond to the pins while re-soldering the pins the solder just fell away from some of the pins and the pins were dark and tarnished with no solder stuck to them at all . So applying liquid rosin flux and re-soldering slowly to allow the flux to clean the connections better did the job on this one . 73 Bob
Final test run of the repaired Ten Tec Omni 6 Plus for 24 hours . I said "Microprocessor board" no that was wrong it was the PLL (Phase locked loop ) Board that was the only board I worked on . After doing this repair I am of the opinion that the PLL board in this one went through the wave soldering machine to fast the solder coated the connecting pins on the little transformers but did not actually bond to the pins while re-soldering the pins the solder just fell away from some of the pins and the pins were dark and tarnished with no solder stuck to them at all . So applying liquid rosin flux and re-soldering slowly to allow the flux to clean the connections better did the job on this one . 73 Bob
