Part 3 X&Yaxis - MirageC's HyperCube Evolution Build Lessons Learned. Data sourced from DaHai8 @MirageC

MirageC | Part 3 X&Yaxis - MirageC's HyperCube Evolution Build Lessons Learned. Data sourced from DaHai8 @MirageC | Uploaded July 2018 | Updated October 2024, 5 days ago.
Here are a couple of my lessons learned while builing my HEVO based on Dahai8's instruction.

Thingiverse Page: thingiverse.com/make:514479

DaHai8's Build: thingiverse.com/thing:2847400

Could this new control board be enough? - Unboxing SKR3 EZ from BTT

Humidity has more impact than you think on your prints!

X4 Stepper Motors - AWD HevORT with short belt path

Resume 3D print after pause and print surface removal.

500mm/s print speed on HevORT CoreXY MGN Rail 3D Printer - Is it reachable?

HevORT CoreXY Rail MGN - Demo of 3D Printer Printing PLA

Finally! a cooling solution that WORKS! #shorts

319mm/s on HevORT - CoreXY MGN rail - Testing Dynamic Acceleration with Duet3D M593 command

HevORT ZR - Assembly Instruction Z axis Part 1 - Rear Actuator Slider