Part 2 : Working 4 Digit UP counter module using Arduino Uno @learnerswings
Part 2 : Working 4 Digit UP counter module using Arduino Uno  @learnerswings
Uploaded December 2018 | Updated November 2026, 10 hours ago
BUY NOW from below link

haberocean.com/individualProduct?productID=6027

Watch Assembling Video at : youtube.com/watch?v=RVOCRPlzsrM

Working using Arduino : youtube.com/watch?v=xEW6buS3Cdc

Testing by press button switch : youtube.com/watch?v=7jiAAjkpcJ4

Upload the following program to Arduino board.


int clockPin = 12;

void setup() {
// initialize digital pin clockPin as an output.
pinMode(clockPin, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
digitalWrite(clockPin, HIGH);
delay(100); // wait for 10 milliseconds
digitalWrite(clockPin, LOW);
delay(100); // wait for 10 milliseconds
}
Part 2 : Working 4 Digit UP counter module using Arduino UnoCircuit to Read Data from a Water Flow Sensor using Arduino4 digit UP counter module using CD4026, with external RESET option and TEST buttonSimple Trick to Design an Amazing Illumination in 8*8 LED MatrixAnti-theft System using Infra Red, controlled using NE555, LM311 and TSOP IR SensorManual or automatic mode setting | ESP8266  temperature monitoring systemMIC and SPEAKER circuit using VS1003, PAM8610 and ESP323*3*3 LED Cube Construction using Locally Available Materials (Part 4 of 4)How to give subtitles to a video using kdenlive in ubuntu ?Display images in a 2.8 inch TFT Touch Shield using Arduino UNO (Part 2)Seven segment display on bread board - Single digit Up counter using CD4026Simple Circuit to Control 74165 using Arduino Mega
My Funny Electronics |

Part 2 : Working 4 Digit UP counter module using Arduino Uno

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER