sciencetoymaker | Part 14 Build a Putt Putt/Pop Pop Steam Boat s11 glue straw in @sciencetoymaker | Uploaded January 2009 | Updated October 2024, 2 hours ago.
Part 14 is Step 11, measuring 1 1/2" or 39mm from the end of the bendy part of the straws into the small part of the straw. Cut there and apply mixed up, thin, even layer of epoxy to the small part of the straws, but not within 1/4" or 6mm of the bendy part. Put the straws in the end of the aluminum, but only to within 1/4" or 6mm of the bendy part. If a lot of epoxy gets on the bendy part, wipe it off, both above and below.
You can find more DIY science projects like this at sciencetoymaker.org
Part 14 is Step 11, measuring 1 1/2" or 39mm from the end of the bendy part of the straws into the small part of the straw. Cut there and apply mixed up, thin, even layer of epoxy to the small part of the straws, but not within 1/4" or 6mm of the bendy part. Put the straws in the end of the aluminum, but only to within 1/4" or 6mm of the bendy part. If a lot of epoxy gets on the bendy part, wipe it off, both above and below.
You can find more DIY science projects like this at sciencetoymaker.org
