The Woodgineer | Packing Polystyrene Gravestone using Vectric and Workbee CNC @TheWoodgineer | Uploaded October 2023 | Updated October 2024, 1 hour ago.
Somebody said "you should probably do a Halloween Video" so I panicked, got some scrap packing polystyrene onto my CNC and used Vectrics lovely software to whip up a gravestone design for the front garden.

Not bad for a quicky!

If you’re a YouTuber, an awesome tool worth looking at is TubeBuddy!
Please try it out and if you like it remember to use my affiliate link: https://www.Tubebuddy.com/themadmaker

All my videos are edited using Adobe Premiere because it's awesome :)
bit.ly/2zIGikp

Please subscribe and hit notify to be updated when I release new videos and constructive advice/feedback/ideas are all welcome in the comments below!

I can also be found on the following platforms:
thewoodgineer.com
twitter.com/thewoodgineer
facebook.com/TheWoodgineer
instagram.com/woodgineer
patreon.com/thewoodgineer
thewoodgineer@gmail.com

And if you really want to help support the channel please consider signing up on Patreon. I have a few rewards like behind the scenes info, shoutouts, stickers and badges.
patreon.com/m/thewoodgineer

Thanks all!

Oh and don't click this link. Seriously don't.... bit.ly/2A9va4b