output power measurement for christmas motor 1.wmv @woopyjump
output power measurement for christmas motor 1.wmv  @woopyjump
Uploaded August 2011 | Updated November 2026, 5 hours ago
The idea here , is to show a possibility to measure the output mechanical power of the Christmas motor from Ted at www. hereticalbuilders.com.

So i installed a sewingmachine spool on the shaft of the motor. Than i attached a very thin nylon (fishing line ) wire to the spool . Than i hang a weight of exactly 1 newton ( or 102 ,5 grams ) at the end of the wire.

Than i installed a ruler of one meter divided all 10 cm along the trajectory of the lifting weight. And i decided to measure only on the length of 0.5 meter, because i want to avoid that the spool gets on a second layer which could trouble the measurement. on the upper stage.

So i can calculate with this formula. 1 Newton x 1 meter per 1 .second =
1 watt

So as you can test yourself on the video the load needs about 2.6 to 2. 65 second to travel across the 0.5 meter.

so the math is 1 N x 0.5 meter X 1/ 2.65 sec = 0.1886 watt.

I think that this method is good enough for basic measuremt with this very slow spinning motor.

good luck at all

Laurent
output power measurement for christmas motor 1.wmvUFO levitating magnetcharging by induction approach 3.wmvMikhail wheel finger subjectiv feeling 1open circuit can be an  energyraptor ??amazing discovering of an  inductret effect 1.wmvinertial propulsion with gyroscope part 19 motorising the gyroLevitation on ferrite magnet by Manelas and Sweet 1shorting  coil test 2 .wmvinertial propulsion with gyroscope part 12shorting cap freewheeling test 2.wmvMaxi energy pumping with mini kacher 1 .wmv
woopyjump |

output power measurement for christmas motor 1.wmv

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER