Uploaded August 2021 | Updated November 2026, 6 hours ago
In this video, I would like to introduce a new router from GL.iNet, the Beryl MT-1300 Travel Router. It is running OpenWRT and pre-installed with packages such as OpenVPN, WireguardVPN, 3G/4G support and USB tethering, which will help you getting started with OpenWRT without complex installation.
The router is powered by the Dual Core MediaTek MT7621A SoC, clocked 880MHz and supports hardware accelerator upto 2 Gbps. It has 256MB of DDR3 RAM and 32MB internal FLASH. The router has 3 Gigabit Ethernet ports, 1 USB 3.0, an SD card slot, a USB type C port to power the board and 2 external non-detachable dualband WiFi antenna. Wireless speed is 400Mbps for 2.4G WiFi and 867Mbps for 5G WiFi.
I will perform the initial setup with my smartphone and walk you through the Beryl's Web UI. At the end of the video, I will configure OpenVPN client with my phone and run a simple speedtest.
You can check out the Beryl GL-MT1300 here - bit.ly/2W5wRtS
Video timeframe:
00:00 - Beryl GL-MT1300 Introduction
00:17 - Beryl GL-MT1300 Specs & Connector Overview
01:42 - Initial Setup the Beryl GL-MT1300 with Smartphone
02:12 - Connect to the Beryl GL-1300 WiFi & Speedtest
02:52 - Access Beryl's Web GUI
04:46 - Setup OpenVPN on the Beryl GL-MT1300
If there is any tests or question regarding the device, feel free to leave it in the comment section. You can also check the Beryl GL-1300 unbox video here: youtu.be/rZuR-JFDGYY
Thanks for wathcing and see you in the next video!
In this video, I would like to introduce a new router from GL.iNet, the Beryl MT-1300 Travel Router. It is running OpenWRT and pre-installed with packages such as OpenVPN, WireguardVPN, 3G/4G support and USB tethering, which will help you getting started with OpenWRT without complex installation.
The router is powered by the Dual Core MediaTek MT7621A SoC, clocked 880MHz and supports hardware accelerator upto 2 Gbps. It has 256MB of DDR3 RAM and 32MB internal FLASH. The router has 3 Gigabit Ethernet ports, 1 USB 3.0, an SD card slot, a USB type C port to power the board and 2 external non-detachable dualband WiFi antenna. Wireless speed is 400Mbps for 2.4G WiFi and 867Mbps for 5G WiFi.
I will perform the initial setup with my smartphone and walk you through the Beryl's Web UI. At the end of the video, I will configure OpenVPN client with my phone and run a simple speedtest.
You can check out the Beryl GL-MT1300 here - bit.ly/2W5wRtS
Video timeframe:
00:00 - Beryl GL-MT1300 Introduction
00:17 - Beryl GL-MT1300 Specs & Connector Overview
01:42 - Initial Setup the Beryl GL-MT1300 with Smartphone
02:12 - Connect to the Beryl GL-1300 WiFi & Speedtest
02:52 - Access Beryl's Web GUI
04:46 - Setup OpenVPN on the Beryl GL-MT1300
If there is any tests or question regarding the device, feel free to leave it in the comment section. You can also check the Beryl GL-1300 unbox video here: youtu.be/rZuR-JFDGYY
Thanks for wathcing and see you in the next video!










