On-Car Driveshaft Balancing - Part 2 of 2 - Pico NVH Kit @WeberAuto
On-Car Driveshaft Balancing - Part 2 of 2 - Pico NVH Kit  @WeberAuto
Uploaded May 2016 | Updated November 2026, 4 days ago
Weber State University (WSU) - Automotive Technology Department - Transmission Lab. In this episode, we use the Pico Technology PicoScope and NHV Analyzer with the optical sensor to balance the rear propeller shaft (driveshaft) on a 2015 SUV. The length of this video is a little shorter than the time it took to complete the entire balancing procedure.

The Optical Sensor comes with the GM CH-51540 Oscilloscope NVH Diagnostic Kit. The Optical Sensor is an optional accessory for the Pico NVH Diagnostic Kit.

http://www.weber.edu/automotive

This video was created and edited by Professor John D. Kelly at WSU. For a full biography, see http://www.weber.edu/automotive/J_Kelly.html
On-Car Driveshaft Balancing - Part 2 of 2 - Pico NVH KitWhy the First Prius Needs Its Electric Motor #shortsWhy Hondas Hybrid Is a Series Hybrid #shortsUniversal Joints - Part 6: Proper U-Joint InstallationInside the Prius Inverter: The Intelligent Power Module #shortsHow Strong Are Hybrid Motor Magnets? #shortsToyota Hybrid Double Overdrive Explained #shortsToyota Hybrid MG2 Motors Compared #shortsFord Hybrid Transaxle Generations - (Toyota Prius P610, Chrysler Pacifica SI-EVT)Which Transmission is in My Toyota or Lexus?How a Prius Drives Away With the Engine Off #shorts2004 - 2009 Prius Transaxle - P112 Deep Dive
WeberAuto |

On-Car Driveshaft Balancing - Part 2 of 2 - Pico NVH Kit

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER