Uploaded December 2014 | Updated September 2026, 3 days ago

---

You're probably itching to make some fun embedded computer projects with ODROID-C1. What you need is an add on prototyping T-breakout board, which can break out all those tasty power, GPIO, I2C, ADC pins from the 40 pin header onto a solderless breadboard. This set will make "cobbling together" prototypes with the ODROID-C1 super easy.

This kit comes with below many items.

- Assembled T-breakout PCB - 40Pin GPIO Breakout board
- Breadboard - 630 Tie-points with dual power lanes
- 40pin Ribbon cable - IDC Flat cable 100mm
- 40pin Male-to-Male Dupont jumper Wire 170mm
- 7 x Green LED 3mm
- 7 x Yellow LED 3mm
- 7 x Red LED 3mm
- 2 x Photo Cell (CdS Light sensor)
- 6 x Tact Swithc
- 50 x 330 Ohm 1/6W resister
- 50 x 10K Ohm 1/6W resister


This video shows you how fun the DIY light level meter is....


hardkernel.com/main/products/prdt_info.php?g_code=G141637532784