MY YAESU FT-991A IPO/ATT FAULT - Frontend gone Bye Bye...... @mike-M0MSN
MY YAESU FT-991A IPO/ATT FAULT - Frontend gone Bye Bye...... @mike-M0MSN
Uploaded May 2020 | Updated September 2026, 3 days ago
Yaesu FT-991A Frontend Fault, I may have a Friday afternoon radio, however. Should a £1,100 radio blow-up and stop working in 2020 because you use it in a multiple operator situation. It is not unusual to find more than one radio in use at any club these days, so more than 1 operator can work a competition on deferent bands. however if one of these radios is the Yaesu FT991A you may have an issue or is it just my 991A ?????

https://www.commswg.site/_amateur_radio/Yaesu_FT991A_FrontEndFailure.php
MY YAESU FT-991A IPO/ATT FAULT - Frontend gone Bye Bye......HAM RADIO: 80M Band Wire Spiral Loop - Magnetic Loop, Small Gardens,Kenwood TS-890s unboxing : Super RadioHAM RADIO: The Figure of 8 Magnetic Loop: MAGLOOP: Coax loop Part 1QRM Eliminator x phaseRADIO HAM: Spiral Loop Capacitor build. Butterfly Capacitor BuildHAM RADIO: Speed Controller Magloop Build: Capacitor tuning Control unitHAM RADIO: Adding the CAPACITOR Building a Coaxial Magnetic Loop Antenna. COAX MAGLOOP:Yaesu FTM-500D/E First impressions: HAM RADIORemake of a 64/1 Unun (transformer) EFHW End feed Half wave.. 80m to 10m AntennaYaesu FT991A - MARS MODAir Source Heat Pump an Air to Air Install : Is My heat pump better than your gas boiler?
Mike-M0MSN |

MY YAESU FT-991A IPO/ATT FAULT - Frontend gone Bye Bye......

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER