My Insane Support Settings for Lychee Slicer @3dprintingpro212
My Insane Support Settings for Lychee Slicer  @3dprintingpro212
Uploaded June 2021 | Updated November 2026, 3 hours ago
Here are my light, Medium and Heavy settings for Lychee slicer to get the best supported, least damaged models!

Support the channel with Pit Fighter or Wukong Kickstarters!
myminifactory.com/campaigns/pit-fighter-130 myminifactory.com/campaigns/wukong-journey-to-the-west-251
My Insane Support Settings for Lychee SlicerOnyx Rigid Pro 3d printer resin test/review, pricey but is it worth?Eryone resin review!  Seen a lot of it lately but is it any good?Jamg-HE Conjure Tough 3d resin review with break testsIve gone over to the Dark Side?  Yes I switched to Lychee for my supporting and slicing!Solving the problem of horizontal lines in your resin prints!Help the victims of La Palma!  Get an amazing model and do some good!Im back, WTF happened to me?  And whats in store?Using Chitubox Part 3: Step by Step support placement on the UmberhulkSupport edges properly to get the best prints and least damage - fix bad Patreon pre-supports!What can I make on my 3D printers for gaming?!? A vid for those who dont own a printer yet!Games Workshop and Reaper quality figure for less than $1 each, save $1,000s
3DPrintingPro |

My "Insane Support Settings" for Lychee Slicer

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER