My H2D softlocked itself for ten minutes #3dprinting @carlthepumpkinman
My H2D softlocked itself for ten minutes #3dprinting  @carlthepumpkinman
Uploaded September 2025 | Updated November 2026, 3 hours ago
So essentially, when a BambuLab uses a filament to the point that the only remaining portion is inside the Bowden tube and not on the spool, it has no mechanism to pull it back, and therefore it needs to just purge it. And theoretically, if you have a really long Bowden tube and a really small nozzle opening... that can take quite a while.
My H2D softlocked itself for ten minutes #3dprintingI held a Second 3D Model Jam #3dprinting #3dmodeling #pumpkinjamHow to Make my Volant Axe | 3D PrintingMartyBOX at #JRRF 2026TOMOWORKS at #JRRF 2026A Smashing Poster Frame #smashbros  #英会話 #3dprinting #pumpkinlordI Held a Third 3D Printable Model Jam | #3dmodeling #3dprinting #pumpkinjamHow to Make Durandal from Fire Emblem: The Blazing Blade | 3D Printing #3dprinting  #fireemblemHistory of the Luxury Ball  #pokemon #projectkurt #英会話 #3dprinting全X種  #英語 #pumpkinlordFresh Juice Figurines  #pumpkinlord #3dprinting #juiceFANTASY GEEK at #JRRF 2026
CarlThePumpkinMan |

My H2D softlocked itself for ten minutes #3dprinting

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER