Uploaded October 2025 | Updated September 2026, 2 weeks ago
I was actually legit embarrassed to show those results, but it is what it is!
Help support this channel! patreon.com/Needitmakeit
A short list to help support this channel, thank you so much for your help!
Bambu P2S - tidd.ly/3ISZkfq (Best value)
Bambu H2S - tidd.ly/4olSRbL (Most options for money)
Bambu H2D - tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos - tidd.ly/4hn6TYI
Bambu Super Tack - tidd.ly/47c81cF
Rode Wireless ME mic (Saved me about 4+ hours/vid) - amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) - amzn.to/3NBFvZe
Rod Sloth - makerworld.com/en/models/120092-rod-sloth-fits-most-3d-printers#profileId-316102
Hand of Rod - patreon.com/Needitmakeit/shop/hand-of-rod-fastest-way-to-clean-your-t8-24340?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=productshare_fan&utm_content=join_link
This was a strange one, the print results were not consistent from one print to another. Printing one object was good, but printing two was bad. The sides were fairly smooth. but the front and back were rough. I've taken good care of my X1C, cleaning, oiling and greasing, so this is a bit strange, so we're going to find out exactly what is causing this, going into this, I have no idea what the cause is, this isn't something I've run into before with a CoreXY printer.
#bambu
#x1carbon
#H2D
I was actually legit embarrassed to show those results, but it is what it is!
Help support this channel! patreon.com/Needitmakeit
A short list to help support this channel, thank you so much for your help!
Bambu P2S - tidd.ly/3ISZkfq (Best value)
Bambu H2S - tidd.ly/4olSRbL (Most options for money)
Bambu H2D - tidd.ly/4q9RsHk (A dual color beast)
Bambu Filament Shown in Videos - tidd.ly/4hn6TYI
Bambu Super Tack - tidd.ly/47c81cF
Rode Wireless ME mic (Saved me about 4+ hours/vid) - amzn.to/3vcMKAr
Mag clip (Super handy, but a little pricy) - amzn.to/3NBFvZe
Rod Sloth - makerworld.com/en/models/120092-rod-sloth-fits-most-3d-printers#profileId-316102
Hand of Rod - patreon.com/Needitmakeit/shop/hand-of-rod-fastest-way-to-clean-your-t8-24340?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=productshare_fan&utm_content=join_link
This was a strange one, the print results were not consistent from one print to another. Printing one object was good, but printing two was bad. The sides were fairly smooth. but the front and back were rough. I've taken good care of my X1C, cleaning, oiling and greasing, so this is a bit strange, so we're going to find out exactly what is causing this, going into this, I have no idea what the cause is, this isn't something I've run into before with a CoreXY printer.
#bambu
#x1carbon
#H2D
