Uploaded September 2021 | Updated September 2026, 10 hours ago
Thank you for watching, I'm always happy to converse, answer questions & happy to take content suggestions for future videos if possible so please leave a comment, I always aspire to answer each and every one!
If this video helped you in any way, please rate the content - I appreciate it very much.
My Gear:
Runcam 5: bit.ly/2OlSnX8
Runcam 3: bit.ly/2sOuQOr
FrSky Taranis X-Lite : bit.ly/2DA8xlI
Aomway Commanders: bit.ly/2xClXuP
Data burst containing the usual information can be found on the outro.
Thank you for watching, I'm always happy to converse, answer questions & happy to take content suggestions for future videos if possible so please leave a comment, I always aspire to answer each and every one!
If this video helped you in any way, please rate the content - I appreciate it very much.
My Gear:
Runcam 5: bit.ly/2OlSnX8
Runcam 3: bit.ly/2sOuQOr
FrSky Taranis X-Lite : bit.ly/2DA8xlI
Aomway Commanders: bit.ly/2xClXuP
Data burst containing the usual information can be found on the outro.
![IGOW 3 Preseason 2 [ Split-S ]](https://i.ytimg.com/vi/P9GtLMQPiKE/mqdefault.jpg "IGOW 3 Preseason 2 [ Split-S ]
IGOW 3 Preseason 2 [ Split-S ]")
![Runcam Split Sensor Board Swap [Mundane Maintenance]](https://i.ytimg.com/vi/PA4ZQ3a0PdU/mqdefault.jpg "Runcam Split Sensor Board Swap [Mundane Maintenance]
Swapping out the CMOS sensor for the Split on my C240.
Runcam Split: http://bit.ly/2CZ8we4
It seems this was another attempt in vain to make good of the original Split.
Runcam was kind enough to send me a new CMOS Senson Board which has rectified the image position but the jello is still evident.
Im going to persist and try a couple more softer mountings, no doubt the ongoing saga is in the playlist or cards.
Thanks for watching, Im always happy to converse and answer questions so please leave a comment,I always aspire to answer each and every one!
If this helped you ,please rate the content,I appriciate it very much.
My Gear:
Runcam 3: http://bit.ly/2sOuQOr
FrSky Taranis Q X7: http://bit.ly/2kCtq8X
M7 Gimbals: http://bit.ly/2rowUg4
Aomway Commanders: http://bit.ly/2xClXuP
ImmersionRC Patch: http://bit.ly/2rTHbld
Here comes the usual boilerplate disclosures being all products are my own unless specifically stated that they were provided by a company for review or testing, some links may be affiliated and all opinions stated are my own and genuine ,good or bad.
I try and keep my content family friendly and exercise safety where applicable, you are responsible for your own actions following guides and instructions I may offer aswell as abiding by local laws etc, Youtube and Myself are absolved of any recourse and liability.
Have fun!")
![Metal Gear Upgrade for the MN90 2 Speed GearBox [ WPL / URUAV / MN90 / JJRC ]](https://i.ytimg.com/vi/PC6cnuogZNk/mqdefault.jpg "Metal Gear Upgrade for the MN90 2 Speed GearBox [ WPL / URUAV / MN90 / JJRC ]
A great quick upgrade for the MN D90 Ultimate, these metal gears in the 2 speed box again take the project way beyond toy grade to make it feel even better!
Gear set: http://bit.ly/2S91vg9
A little info on how they go in and work etc, if you need help drop a comment below & Ill help you as much as possible,
2 Speed Box: http://bit.ly/2XxHB04
MN-90 Kit: http://bit.ly/2Fo6tlp
Thank you for watching, Im always happy to converse, answer questions & happy to take content suggestions for future videos if possible so please leave a comment, I always aspire to answer each and every one!
If this video helped you in any way, please rate the content - I appriciate it very much.
Data burst containing the usual information can be found on the outro.")
![Trouble getting DFU? FIX [ New Flight Controller Bootloader Issue Solution ]](https://i.ytimg.com/vi/PTtqpaIsG_0/mqdefault.jpg "Trouble getting DFU? FIX [ New Flight Controller Bootloader Issue Solution ]
I came across this issue while trying to update an Omnibus F4 to newer firmware.
The parts I was using were this small F4 board: http://bit.ly/2uB23AW (Omnibus F4)
With this small receiver for another device: http://bit.ly/2uTKcEr (Micro D8 /w SBUS)
The crux of it is that all my drivers are correct for STM devices etc (Zadig and Impulses Driver fixer) yet upon trying to put a bootload a flight controller, it would show up as an unknown device/ no drivers etc.
This seems like its either crept in through the configurator or a windows update (seems to affect windows 7 and windows 10 for certain)
Running the Impulse RC Driver fixer throws the error impulse rc driver fixer unexpected number of devices detected
Quite a simple work around and I hope it should be fixed properly in the future as its almost shooting ones own foot off type of deal.
Hope this helps.
Thank you for watching, Im always happy to converse, answer questions & happy to take content suggestions for future videos if possible so please leave a comment, I always aspire to answer each and every one!
If this video helped you in any way, please rate the content - I appriciate it very much.
Data burst containing the usual information can be found on the outro.")
![Common Friends [ Some R&R ]](https://i.ytimg.com/vi/QTXDaHQJeG4/mqdefault.jpg "Common Friends [ Some R&R ]
Thanks for a great outing, Crew!
[Music]
Track: Lost Sky - Where We Started (feat. Jex) [NCS Release]
Music provided by NoCopyrightSounds.
Watch: https://youtu.be/U9pGr6KMdyg
Free Download / Stream: http://ncs.io/WhereWeStarted")
![RaceGOW 5 [ Track 4 ]](https://i.ytimg.com/vi/Qe8IFbioIYc/mqdefault.jpg "RaceGOW 5 [ Track 4 ]
6 Packs as usual!
Got hold of a Nanoscout..")
![IGOW 4 Week - 1 [ WeBLEED Orbits ] TEABLEED!](https://i.ytimg.com/vi/QpZruJoD0zI/mqdefault.jpg "IGOW 4 Week - 1 [ WeBLEED Orbits ] TEABLEED!
A trip to a local monument for the orbits - We got buzzed by a Puma that was below the tree line hooning around.
#igow4 #fpv #webleed
1st Baron Wantage:
https://en.wikipedia.org/wiki/Robert_Loyd-Lindsay,_1st_Baron_Wantage
The Ridgeway:
https://www.historic-uk.com/HistoryMagazine/DestinationsUK/The-Ridgeway/
A huge thanks to @Gemfanhobby for keeping us in the air!
[Music]
Track: Rxm リム - LOOK AT ME! [NCS Release]
Music provided by NoCopyrightSounds.
Watch: http://ncs.lnk.to/LOOKATMEAT/youtube
Free Download / Stream: http://ncs.io/LOOKATME")
![RaceGOW Track 9 [ No Excuses - Just Regrets ]](https://i.ytimg.com/vi/QwSd29fQSII/mqdefault.jpg "RaceGOW Track 9 [ No Excuses - Just Regrets ]
#racegow #whoop #fpv")
![TS100 [Awesome Opensource Soldering Iron]](https://i.ytimg.com/vi/R0JxNKT7jnk/mqdefault.jpg "TS100 [Awesome Opensource Soldering Iron]
Been using this for ages, holds its own against expensive soldering stations on all but the heaviest of wire gauges.
TS100: http://bit.ly/2QjnLEP (Discount Code: BGTS100)
Case: http://bit.ly/39yzlTQ
Thank you for watching, Im always happy to converse, answer questions & happy to take content suggestions for future videos if possible so please leave a comment, I always aspire to answer each and every one!
If this video helped you in any way, please rate the content - I appriciate it very much.
My Gear:
Runcam 5: http://bit.ly/2OlSnX8
Runcam 3: http://bit.ly/2sOuQOr
FrSky Taranis X-Lite : http://bit.ly/2DA8xlI
Aomway Commanders: http://bit.ly/2xClXuP
Data burst containing the usual information can be found on the outro.")
![IGOW 4 Week - 7 [ HDZero Trippys ]](https://i.ytimg.com/vi/R7d7JGfPTJM/mqdefault.jpg "IGOW 4 Week - 7 [ HDZero Trippys ]
HDZero Trippy Spins - Got it done with a swing in the weather that was rather hot!
Not the best but should tick the boxes.
#igow4 #hdzero #fpv")
