Uploaded November 2021 | Updated September 2026, 5 hours ago

---

P2 Motor Overhaul, Repulsion - Induction, 1 Hp, 1 Ph, 110 / 220 VAC
I refurbish the commutator, replace bearings, Clean & Paint, Test Run.

Delta Table Saw & Jointer Restoration.
This is a Model 1160 Delta 10" Tilting Table Cabinet Style Table Saw, built somewhere between 1937 and 1941. The table saw is a tilting table cabinet saw. The table saw has been in the family since new.

The Jointer is a Model 654, 6" Jointer (Old Style). This Jointer was supplied on the same stand as the Table saw, using the same motor. Gary Brown of Old Iron Machine Works on You Tube donated the correct Jointer for this project.

Be Sure to check out:
Part 1: youtu.be/SwBT1lKDO28
Part 2: youtu.be/Lyh-RCEPXQ4
Part 3: youtu.be/XKKfZy9n0BI
Part 4: youtu.be/HdUnbTt9vlU
Part 5: youtu.be/HWdZ5GxEqnI
Part 6: youtu.be/TEkxkFU2Q3w
Part 7 - 1: youtu.be/PNy_9XtDU3I
Part 7 -2: youtu.be/l8TtZPTWmTI
Part 8: youtu.be/0Sei-XI-SKo
Part 9: youtu.be/TA3ewLEQci0
Badges Installation: youtu.be/yTUNPTyd0Ec

Old Iron Machine Works : youtube.com/c/OldIronMachineWorks

00:00 - Intro
00:54 - Commutator Discussion
05:53 - Undercutting
08:54 - Sanding the Commutator
11:54 - Mounted in the Lathe
12:44 - Cutting Commutator in Lathe
14:11 - Cleanup after the Lathe work
15:08 - A Recommended book for Motor reference
18:24 - The Shorting Ring
22:34 - Bearing install
23:13 - End Bell 1 install
25:06 - Armature install
25:39 - Brush Rig install
26:33 - End Bell 2 install
29:16 - Setting initial brush angle
32:04 - Electrical Box install ( Motor Pot Head)
32:42 - Motor Data Plate install
33:48 - Motor Test Run and Brush Setup
36:20 - Before and After Shot

Please Support the channel:

🎯Buy Me Coffee: buymeacoffee.com/rrintheshop
🎯Subscribe: youtube.com/user/Catfish6945?sub_confirmation=1
🎯Instagram: instagram.com/rrintheshop

🎯Knocker, Dovetail Cutter and Scribe info: Email To:
RRINTHESHOP@GMAIL.COM

#deltatablesaw#restoration#tablesaw