Uploaded April 2024 | Updated November 2026, 3 hours ago
0:00 - Intro
0:29 - DIY Line Bore Introduction
1:00 - New / Old Pin Comparison
1:07 - Main Loader Pin Fit Demonstration
2:14- New Pin Doesn't Fit Loader Arm
2:30 - Purpose of Line Boring
3:00 - Inserting Line Bore Shaft into Boom
3:23 - Bearing Brackets
3:47 - Pillow Block Bearings
4:37 - Line Bore Components Order of Assembly
6:51 - Bearing Locations / Alignment
8:25 - Welding Bearing Brackets
9:57 - Alignment Cones
10:24 - Alignment Problem
17:03 - Porta Power to Spread the Loader Arms
20:04 - Measuring Pin - Pin Before Boring
21:08 - Final Alignment Verification
21:45 - Welding on outside Bearing Brackets
22:00 - Cutting Tool Overview
22:26 - Installing Cutting Bit into Bar
23:53 - Cutting Tool Depth Adjustment
25:19 - Feed Mechanism
26:05 - First Cut
27:00 - Cut Close-up
27:37 - Results of Cut
28:03 - First Measurement after Cut
28:30 - Final Results of Boring
29:53 - Metal Shavings From Cut
30:15 - Finish Honing
31:21 - Final Measurements
31:40 - Test Fitting New Pin
32:05 - Reposition Machine for Test Fitting Boom
38:50 - Lifting the Cab Off
40:30 - Lifting the Loader Boom
41:48 - Fitting the Loader to Main Frame
43:40 - Analyzing the Fitment of the Loader
44:30 - Loader Fitment Problem
45:30 - Final Thoughts
3:35 - Line Bore Bearing Setup
0:00 - Intro
0:29 - DIY Line Bore Introduction
1:00 - New / Old Pin Comparison
1:07 - Main Loader Pin Fit Demonstration
2:14- New Pin Doesn't Fit Loader Arm
2:30 - Purpose of Line Boring
3:00 - Inserting Line Bore Shaft into Boom
3:23 - Bearing Brackets
3:47 - Pillow Block Bearings
4:37 - Line Bore Components Order of Assembly
6:51 - Bearing Locations / Alignment
8:25 - Welding Bearing Brackets
9:57 - Alignment Cones
10:24 - Alignment Problem
17:03 - Porta Power to Spread the Loader Arms
20:04 - Measuring Pin - Pin Before Boring
21:08 - Final Alignment Verification
21:45 - Welding on outside Bearing Brackets
22:00 - Cutting Tool Overview
22:26 - Installing Cutting Bit into Bar
23:53 - Cutting Tool Depth Adjustment
25:19 - Feed Mechanism
26:05 - First Cut
27:00 - Cut Close-up
27:37 - Results of Cut
28:03 - First Measurement after Cut
28:30 - Final Results of Boring
29:53 - Metal Shavings From Cut
30:15 - Finish Honing
31:21 - Final Measurements
31:40 - Test Fitting New Pin
32:05 - Reposition Machine for Test Fitting Boom
38:50 - Lifting the Cab Off
40:30 - Lifting the Loader Boom
41:48 - Fitting the Loader to Main Frame
43:40 - Analyzing the Fitment of the Loader
44:30 - Loader Fitment Problem
45:30 - Final Thoughts
3:35 - Line Bore Bearing Setup










