Uploaded January 2017 | Updated November 2026, 2 days ago
Subscribe for more stuff.
Ask me questions on Twitch!
Follow me on Social Media!
Instagram: @jamezsgames
Twitch: jamezsGames twitch.tv/jamezsgames
Stream Schedule:
Monday, Tuesday, Wednesday 6:30 PM EST
I will make a video explaining how this works later. I made what's called an Astable Multivibrator circuit to mimic the flashing of grade crossings. I will upload the schematic later. This circuit takes in about 16.5V of AC current, full wave rectifies it, then throws the input into an astable multivibrator circuit with two NPN transistors. When current enters in the off transistor, it creates an open circuit due to reaching the cutoff point while charging a capacitor. This side is represented by logical 0 (i.e.. the bulb is turned off). The capacitor then discharges into the second transistor's base. This then causes the opposite transistor to reach saturation and act like a short and become logical 1 (i.e.. bulb is turned on). If an oscilloscope was hooked up to the bulb, it would look like a square waveform to 0 and repeating, similar to a sinusoidal nature, but half wave rectified. Frequency of the waveform can be calculated pretty easily from this configuration as well. Changing the impedance in the circuit can cause the bulbs to be on at different times.
Components are:
1 200V 2A Diode
1 1000 uF 50V Capacitor
2 220 uF 50V Capacitors
2 39K Resistors (2W)
2 200 Ohm Resistors (2W)
2 NPN 2N3055G Transistors 60V 15A
Subscribe for more stuff.
Ask me questions on Twitch!
Follow me on Social Media!
Instagram: @jamezsgames
Twitch: jamezsGames twitch.tv/jamezsgames
Stream Schedule:
Monday, Tuesday, Wednesday 6:30 PM EST
I will make a video explaining how this works later. I made what's called an Astable Multivibrator circuit to mimic the flashing of grade crossings. I will upload the schematic later. This circuit takes in about 16.5V of AC current, full wave rectifies it, then throws the input into an astable multivibrator circuit with two NPN transistors. When current enters in the off transistor, it creates an open circuit due to reaching the cutoff point while charging a capacitor. This side is represented by logical 0 (i.e.. the bulb is turned off). The capacitor then discharges into the second transistor's base. This then causes the opposite transistor to reach saturation and act like a short and become logical 1 (i.e.. bulb is turned on). If an oscilloscope was hooked up to the bulb, it would look like a square waveform to 0 and repeating, similar to a sinusoidal nature, but half wave rectified. Frequency of the waveform can be calculated pretty easily from this configuration as well. Changing the impedance in the circuit can cause the bulbs to be on at different times.
Components are:
1 200V 2A Diode
1 1000 uF 50V Capacitor
2 220 uF 50V Capacitors
2 39K Resistors (2W)
2 200 Ohm Resistors (2W)
2 NPN 2N3055G Transistors 60V 15A
![Why was the PS3 Difficult to Develop Games For?
This continues my development challenges series.
Ask me questions on Twitch!
Check out the newest one in the series, the Atari Jaguar!
https://www.youtube.com/watch?v=Tp2-59pZOYU
Follow me on Social Media!
Instagram: @jamezsgames
Twitch: jamezsGames https://www.twitch.tv/jamezsgames
Stream Schedule:
Monday, Tuesday, Wednesday 6:30 PM EST
Here are all the sources for the diagrams:
[1] https://gamingbolt.com/developer-explains-what-its-like-developing-for-each-console-ps3-being-the-hardest
[2] https://research.ncl.ac.uk/game/mastersdegree/workshops/ps3introduction/Tutorial0.pdf
[3] https://www.researchgate.net/figure/Element-Interconnect-Bus-EIB_fig2_263273005
[4] https://www.gamasutra.com/view/feature/131168/a_glimpse_inside_the_cell_processor.php?print=1
[5] http://www.blachford.info/computer/Cell/Cell1_v2.html
Huge shout out to Nicholas Blachfords content. go visit his website!
Here is the open course from MIT on the Cell stuff:
https://ocw.mit.edu/courses/electrical-engineering-and-computer-science/6-189-multicore-programming-primer-january-iap-2007/index.htm
Have any more ideas for development challenge videos? Leave them in the comments below. Be sure to like the video! Why was the PS3 Difficult to Develop Games For?](https://i.ytimg.com/vi/W0-NEwh1m2c/mqdefault.jpg)









