Moen | MM3 Prototype Marble Dropper V1 @moen3249 | Uploaded April 2022 | Updated October 2024, 47 minutes ago.
From model posted by wintergatan 6. april 2022
This model i downscaled to 79% to match the 15,9 mm marbles I had laying around.
At the end there I am going a bit to fast. then slowing down to a more confertable high speed.
Escapement wheel/anchor seems to work fine there is no back rotation when pulling. But when pushing the wheel goes a little counterclockwise.
The arm that is holding the lower marble requires more force than i expected. I am not sure if that is a huge issue. It is a detail to consider.
From model posted by wintergatan 6. april 2022
This model i downscaled to 79% to match the 15,9 mm marbles I had laying around.
At the end there I am going a bit to fast. then slowing down to a more confertable high speed.
Escapement wheel/anchor seems to work fine there is no back rotation when pulling. But when pushing the wheel goes a little counterclockwise.
The arm that is holding the lower marble requires more force than i expected. I am not sure if that is a huge issue. It is a detail to consider.
