Uploaded May 2017 | Updated September 2026, 2 hours ago

---

This video is how I upgraded the carriage clamps to use individually adjustable ball bearings on the MINI LATHE. (MUCH) More information below!

Please like and subscribe if this was helpful!

Stuff from this video:
Transfer Punches: amzn.to/2pQ4oGi
Set Screws: amzn.to/2q9YgcZ
Loctite: amzn.to/2ps8Mes
Tap and Die Set: amzn.to/2pBk6SB

Vinyl Cutter: amzn.to/2pQNLZg
Vinyl: amzn.to/2qCprgC

Lathe: amzn.to/2nVBrEc

Stuff on the lathe:
Quick Change Tool Holder: amzn.to/2oZtFee
Tailstock Drill Chuck: amzn.to/2pmE0jX

Lathe tools:
Boring Bar: amzn.to/2pmy0b1
Carbide Tools: amzn.to/2oRZWax
Parting Tool: amzn.to/2nVCeW1
Center Bits: amzn.to/2oRRV5n
Drill Bits: amzn.to/2oz9W76

Other stuff:
Cutting oil: amzn.to/2ofkPaY

Mini Lathe troubleshooting guide: littlemachineshop.com/reference/drivetroubleshooting.pdf

Controller board wiring configuration: imgur.com/KIEzu92

The real version of the motor controller: amzn.to/2orw43F
Datasheet for the KBIC-120: galco.com/buy/KB-Electronics/KBiC-120

Super nice guy who repairs the controller boards: olduhfguy.com

Music:
soundcloud.com/jeff-kaale
soundcloud.com/andrewapplepie
soundcloud.com/dyallas
soundcloud.com/maxzwell
soundcloud.com/joakimkarud