Milling fixture for long tapered shafts @thang010146
Milling fixture for long tapered shafts  @thang010146
Uploaded October 2026 | Updated November 2026, 14 hours ago
This fixture is used for milling a longitudinal groove along a long, tapered, pink-colored shaft made of aluminum.
The shaft is clamped between two long, rotatable yellow clamping jaws.
The green screw pushes the tapered shaft, causing the clamping jaws to rotate and grip the shaft tightly.
A small spring-loaded pin (red) is positioned to set the angular orientation of the shaft, facilitating the milling of another symmetrical groove.
The blue nut can be rotated to the side to allow the pink shaft to be inserted or removed.
This video was made at the request of a YouTube viewer from India.
This fixture has not yet been tested in practice.
Note: If the tapered shaft is manufactured with large tolerances, its axial position after clamping may vary significantly.

STEP files of this video:
mediafire.com/file/uekm5v79wiio6g1/MillFixtureTaperShaftSTEP.7z/file

A related video:
youtu.be/uFNXexNOm5A
Milling fixture for long tapered shaftsTwo wedge mechanismSlat window 4Two stage gear multiplierKey clutchControlling motion of curved slider 2Cone clutch
thang010146 |

Milling fixture for long tapered shafts

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER