Uploaded October 2022 | Updated November 2026, 15 hours ago
On the side of a piece of wood I was cutting up on the bandsaw, I found a place where a branch had been cut off from the trunk of the tree. It looked like a nice piece that I could turn on the lathe into a bowl. I cut this particular piece of wood out of the larger piece I was working on and put it on the lathe and began to turn it. I found that the center of this piece, that used to be the branch, had completely rotted away and I ended up having to cut off what was going to be the bottom of the bowl. I made a segmented ring and glued it to the bottom of the bowl, making a new bottom to the bowl. It is made from pieces of the same maple tree and some thin walnut inserts. I also had an angled section on the top of the bowl that was missing. I made a segmented piece similar to the ring and glued it to the top of the bowl. It makes a wedge-shaped segmented section on the rim. I finished the bowl with tung oil. I like the juxtaposition of the monolithic section of the bowl and the very regular segmented sections of the bowl.
Tools used in this project can be found at
frankmakes.com/
Woodturning tools: carterandsontoolworks.com
To see upcoming projects follow me on social media
Patreon
patreon.com/user?u=16151185
Instagram
instagram.com/frank.howarth
Twitter
twitter.com/FrankHowarth
Facebook
facebook.com/FrankMakes
0:00 (introduction)
0:40 (wood turning)
10:13 (conclusion)
On the side of a piece of wood I was cutting up on the bandsaw, I found a place where a branch had been cut off from the trunk of the tree. It looked like a nice piece that I could turn on the lathe into a bowl. I cut this particular piece of wood out of the larger piece I was working on and put it on the lathe and began to turn it. I found that the center of this piece, that used to be the branch, had completely rotted away and I ended up having to cut off what was going to be the bottom of the bowl. I made a segmented ring and glued it to the bottom of the bowl, making a new bottom to the bowl. It is made from pieces of the same maple tree and some thin walnut inserts. I also had an angled section on the top of the bowl that was missing. I made a segmented piece similar to the ring and glued it to the top of the bowl. It makes a wedge-shaped segmented section on the rim. I finished the bowl with tung oil. I like the juxtaposition of the monolithic section of the bowl and the very regular segmented sections of the bowl.
Tools used in this project can be found at
frankmakes.com/
Woodturning tools: carterandsontoolworks.com
To see upcoming projects follow me on social media
Patreon
patreon.com/user?u=16151185
instagram.com/frank.howarth
twitter.com/FrankHowarth
facebook.com/FrankMakes
0:00 (introduction)
0:40 (wood turning)
10:13 (conclusion)




