Map Function Part 2 | How to Trace PV Strings Using the Receiver | Fluke GFL-1500 Tutorial @fluke
Map Function Part 2 | How to Trace PV Strings Using the Receiver | Fluke GFL-1500 Tutorial  @fluke
Uploaded October 2025 | Updated November 2026, 11 hours ago
This follow-up to Part 1 demonstrates how to physically trace PV strings using the GFL-1500 receiver. Learn correct receiver orientation, signal alignment, and mapping techniques that allow accurate documentation of the array layout — even on rooftop installations.

The video also shows how to identify start- and end-points of strings and translate findings into drawings for maintenance planning. You’ll gain confidence in mapping without stepping on modules or disturbing live systems.

A practical close-out to the Map Mode section of the GFL-1500 training series.

Learn more: fluke.com/en-us/product/electrical-testing/best-solar-energy-industry-tools/fluke-gfl-1500
Map Function Part 2 | How to Trace PV Strings Using the Receiver | Fluke GFL-1500 TutorialIntroducing the VibGuardFluke DMMFluke GFL-1500 Signal Modes: High, Low, and Band Pass ExplainedHow to Use Fluke Connect with the Fluke 283 FC Multimeter | Share Data InstantlyFluke 1670 Series MFT Tips and Tricks | On Screen Help FunctionFluke Multifunction Installation TesterFluke DMM in near spaceUnboxing the Fluke 1673 Installation Tester | Setup, Configuration, & Calibration TipsFluke Acoustic Imager x ElectroboomWhat Is Current? | Understanding Electrical Flow and Measurement BasicsFluke Tools
Fluke Corporation |

Map Function Part 2 | How to Trace PV Strings Using the Receiver | Fluke GFL-1500 Tutorial

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER