Making an Anderson Power Pole Connector Wire @HR4NT
Making an Anderson Power Pole Connector Wire  @HR4NT
Uploaded June 2021 | Updated November 2026, 3 hours ago
In this video, as a part of my new How To series, we are making an Anderson Power Pole connector wire for the Bioenno solar gear I reviewed previously. It is relatively easy to do and only requires a few tools. All tools used in the video are down below.

Tools Used:
Irwin Wire strippers:amzn.to/3g6dXuw
TC-1 Ratcheting Anderson Power Pole Crimpers: amzn.to/3vi0Tqx
14 AWG 200 degree Celsius Wire: amzn.to/2TLtV4w
Powerwerx Anderson Power Pole Connectors:bit.ly/3ivdxzC


Facebook: facebook.com/groups/hr4nt
Website: hamradiofornontechies.com

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

My Current Shack Setup:

Yaesu FT-991A – hamradio.com/detail.cfm?pid=H0-015268
Chameleon MPAS 2.0 Antenna – bit.ly/394f3TO
Diamond X-30A Antenna - hamradio.com/detail.cfm?pid=H0-007913
Diamond GZV4000 Power Supply - hamradio.com/detail.cfm?pid=H0-003067
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
#hr4nt
#ki5npl
#hamradiofornontechies
Making an Anderson Power Pole Connector WireMPAS 2.0 Antenna Review AdditionSome Updates, Mistakes and Premature WordsWhat does the Q of an antenna mean?  Its easier than you may think.A Tale of Two Radios - 991A - VS- IC-7300My 705 POTA Gear Kit - Parks on the AirA Tale of Two Radios - Running two radios with one antennaHow to reduce RFI in your Shack EasilyHam Radio and Disaster PreparednessMy Top Base Station Ham Radio Choices in 2021What Are Band Pass Filters and Why Would you Use them?Resources for New Hams:  You are NOT Alone!
Ham Radio For Non-Techies |

Making an Anderson Power Pole Connector Wire

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER