Uploaded July 2022 | Updated September 2026, 2 days ago
This is a fun project that is easy to do. Most any dark ceramic floor or wall tile works great. I will cover allot of info about how to reduce engraving times with the use of engraving speed, and Lines per inch. I will also demonstrate when to use the flood fill option and when not to. We take this project from the initial engrave estimate from 1 hour and 48 minutes to actual run time of 35 minutes. I show you how to recover from a section of the design that didn’t get lasered due to contamination on the nose cone. Just by knowing what options are available in lightburn.
This is a fun project that is easy to do. Most any dark ceramic floor or wall tile works great. I will cover allot of info about how to reduce engraving times with the use of engraving speed, and Lines per inch. I will also demonstrate when to use the flood fill option and when not to. We take this project from the initial engrave estimate from 1 hour and 48 minutes to actual run time of 35 minutes. I show you how to recover from a section of the design that didn’t get lasered due to contamination on the nose cone. Just by knowing what options are available in lightburn.
