Uploaded September 2017 | Updated September 2026, 2 hours ago

---

This video is how to make a new flag holder for a mailbox that isn't terrible and actually stays in the position it's supposed to on the MINI LATHE. (MUCH) More information below!

Please like and subscribe if this was helpful!

Stuff from this video:
Transfer/Center Punches: amzn.to/2pQ4oGi
Layout Fluid: amzn.to/2qhZeDr
Green Loctite 680: amzn.to/2qhVSAd
Ball Bearing: amzn.to/2eZot6I
Neodymium Magnets: amzn.to/2xDOnIc
Tap and Die Set: amzn.to/2pBk6SB
M6 SS Cap Screw: amzn.to/2f951b9
M4 SS Cap Screw: amzn.to/2wft3c4

Lathe: amzn.to/2nVBrEc

Stuff on the lathe:
Quick Change Tool Holder: amzn.to/2oZtFee
Tailstock Drill Chuck: amzn.to/2pmE0jX

Lathe tools:
Boring Bar: amzn.to/2pmy0b1
Carbide Tools: amzn.to/2oRZWax
Parting Tool: amzn.to/2nVCeW1
Center Bits: amzn.to/2oRRV5n
Drill Bits: amzn.to/2oz9W76

Other stuff:
Cutting oil: amzn.to/2ofkPaY

Mini Lathe troubleshooting guide: littlemachineshop.com/reference/drivetroubleshooting.pdf

Controller board wiring configuration: imgur.com/KIEzu92

The real version of the motor controller: amzn.to/2orw43F
Datasheet for the KBIC-120: galco.com/buy/KB-Electronics/KBiC-120

Super nice guy who repairs the controller boards: olduhfguy.com