Uploaded March 2015 | Updated November 2026, 3 hours ago
In this sixth and final video in my series of videos about making a tool rest (without welding!), I braze the arm to the post, and then the wear strip to the arm. After cleaning up the new tool rest, I cut and adjust the height on the lathe.
The manufacturer's video on using the oxy-mapp torch is here:
youtu.be/a38PdQkcInA
Jan 23 2016 - this just in! Lyle Jamieson passed on a suggestion to put a wedge of wood in the right angle of the angle iron, so that if the tool slips off the end (or even the lip) of the rest, you'll be less likely of catching a finger or two. Sounds like a good idea to me.
In this sixth and final video in my series of videos about making a tool rest (without welding!), I braze the arm to the post, and then the wear strip to the arm. After cleaning up the new tool rest, I cut and adjust the height on the lathe.
The manufacturer's video on using the oxy-mapp torch is here:
youtu.be/a38PdQkcInA
Jan 23 2016 - this just in! Lyle Jamieson passed on a suggestion to put a wedge of wood in the right angle of the angle iron, so that if the tool slips off the end (or even the lip) of the rest, you'll be less likely of catching a finger or two. Sounds like a good idea to me.










