Jer Schmidt | Make a dead blow mallet on the X-Carve @Jer_Schmidt | Uploaded September 2015 | Updated October 2024, 2 hours ago.
Making a dead blow mallet, from plywood, using the X-carve. And my review of the X-carve.
Steve Ramsey's mallet build:
youtube.com/watch?v=JcaV5jWpR1k
Inventables project page, where you can get the SVG to make your own mallet:
inventables.com/projects/make-a-dead-blow-mallet
Inventables website:
inventables.com
Thank you for your interest, good luck in building your own!
Support me on Patreon:
patreon.com/JerSchmidt
Making a dead blow mallet, from plywood, using the X-carve. And my review of the X-carve.
Steve Ramsey's mallet build:
youtube.com/watch?v=JcaV5jWpR1k
Inventables project page, where you can get the SVG to make your own mallet:
inventables.com/projects/make-a-dead-blow-mallet
Inventables website:
inventables.com
Thank you for your interest, good luck in building your own!
Support me on Patreon:
patreon.com/JerSchmidt