Machining & Soldering Upcycled Brass Door Knob Oil Lamp 4/11 @SteveJordan
Machining & Soldering Upcycled Brass Door Knob Oil Lamp 4/11 @SteveJordan
Uploaded November 2020 | Updated September 2026, 2 weeks ago
See how I make a small oil/candle lamp from an old brass door knob. I make this one on the Myford ML7 . (The machining views are somewhat shortened to keep the video as short as possible).
Machining & Soldering Upcycled Brass Door Knob Oil Lamp 4/11Views From The Highest Point In Barnstaple North DevonASTROLUX FT03 Flashlight & Holster/Bag ReviewMy New Designed Spirit Stove coupled with a woodburning stove.How To Convert A Gas Cylinder: Making A Compressor Air Tank.INGCO CSDL10403 CORDLESS SCREWDRIVER REVIEW AND ALTERNATIVE USE.A Mini Lathe piggy back chuck setup for quick small 4 jaw machining work.MINI LATHE TOOLPOST BLOCK ADJUSTMENT & INDEX DRILLINGMaking A BSA Ultra Muzzle Brake. Milling On The Myford ML75000W RECHARGABLE PORTABLE SPOT SPOT WELDER MACHINEEachine ET1 Hit & Miss Engine Running On Supreme Unleaded FuelJCD 8898 Two in one SMD Soldering Iron & Heat Gun Rework Station Review
Steve Jordan |

Machining & Soldering Upcycled Brass Door Knob Oil Lamp 4/11

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER