CNCnutz (Peter Passuello) | Mach3 RS485 spindle control - CNCnutz Episode 147 @cncnutz | Uploaded 7 years ago | Updated 7 hours ago
Turn your spindle on / off and control its speed with only 2 wires.
For more info on this video and where to get the plugins please check out.
http://www.cncnutz.com/2017/05/mach3-and-uccnc-spindle-control-with.html
SHARE WITH OTHERS:
youtube.com/user/cncnutz
SOCIAL:
www.cncnutz.com
Email: cncnutz65@gmail.com
youtube.com/user/cncnutz
facebook.com/CNCnutz
twitter.com/cncnutz
DISCLAIMER:
CNC machines and other power tools are dangerous when used incorrectly. These videos are for entertainment purposes. I can accept no responsibility for any injuries you may incur from replication of what you see in these videos. I aim to demonstrate safe procedures but before attempting any project you should have prior machining experience or have done further research. If you are in any doubt about your safety you should look for an alternative method.
I hope you enjoy.
Turn your spindle on / off and control its speed with only 2 wires.
For more info on this video and where to get the plugins please check out.
http://www.cncnutz.com/2017/05/mach3-and-uccnc-spindle-control-with.html
SHARE WITH OTHERS:
youtube.com/user/cncnutz
SOCIAL:
www.cncnutz.com
Email: cncnutz65@gmail.com
youtube.com/user/cncnutz
facebook.com/CNCnutz
twitter.com/cncnutz
DISCLAIMER:
CNC machines and other power tools are dangerous when used incorrectly. These videos are for entertainment purposes. I can accept no responsibility for any injuries you may incur from replication of what you see in these videos. I aim to demonstrate safe procedures but before attempting any project you should have prior machining experience or have done further research. If you are in any doubt about your safety you should look for an alternative method.
I hope you enjoy.