Uploaded May 2013 | Updated November 2026, 5 hours ago
Hi all
This is the continuation of my testing on LENR
Basic infos
there is 600 ml of tap water mixed with 2.5 grams of NaHCO3 (0.05 mole )
The cathode is Tungstene /lanthane 2.4 mm diameter and 1.5 cm length.
The anode is inox 3 mm diameter screw rod
Temperature of reaction start is 93 degrees
This time i will approach a mean to use the output gaz of the reactor.
So as you can see i have inserted the Security- buller inside the reactor in order to warm the water , so the vapor will not condensate in the buller, and get out almost unchanged.
In my previous test, i simply made some comparisons of heating between the reactor and the thermoplongeur.
This time i will try to get the best ratio of HHo ( which is anyway weak on this set up), and the vapor when i go above the boiling point.
So the idea is to get a "special mixed gaz " which i intend to inject directly in the carburator of a motor, and ignite it with a plasma sparkplug.
Next step is to thermically insulate the reactor , so the input power will be lower ??
Youp a nice challenge
Hope this will work, and if not i will try something else!!
good luck at all
Laurent
Hi all
This is the continuation of my testing on LENR
Basic infos
there is 600 ml of tap water mixed with 2.5 grams of NaHCO3 (0.05 mole )
The cathode is Tungstene /lanthane 2.4 mm diameter and 1.5 cm length.
The anode is inox 3 mm diameter screw rod
Temperature of reaction start is 93 degrees
This time i will approach a mean to use the output gaz of the reactor.
So as you can see i have inserted the Security- buller inside the reactor in order to warm the water , so the vapor will not condensate in the buller, and get out almost unchanged.
In my previous test, i simply made some comparisons of heating between the reactor and the thermoplongeur.
This time i will try to get the best ratio of HHo ( which is anyway weak on this set up), and the vapor when i go above the boiling point.
So the idea is to get a "special mixed gaz " which i intend to inject directly in the carburator of a motor, and ignite it with a plasma sparkplug.
Next step is to thermically insulate the reactor , so the input power will be lower ??
Youp a nice challenge
Hope this will work, and if not i will try something else!!
good luck at all
Laurent










