LEDE Room @MrAudioSoundImages
LEDE Room  @MrAudioSoundImages
Uploaded July 2014 | Updated November 2026, 3 hours ago
Prior to the 1980s, recording studio control rooms were tuned this way. Pink noise (noise with equal energy in every octave) was played through the control room speakers. The output was monitored with a real time analyzer, and a graphic equalizer was adjusted so that the frequency response for the room was flat. This process had some drawbacks in that the room response was dependent on the playback volume. Also, having more or fewer people in the room, changed the frequency response as well.

LEDE is an acronym for live end dead end room design. It doesn't use the equalizer to tweak the room response. Instead, it presumes that any frequency response anomalies are actually produced by standing wave patterns. So the LEDE control rooms attempt to eliminate these standing waves. To do this, the end of the room with the monitor speakers has all soft panels and carpet, making it the "dead end". The other half of the room has bare floors and hard walls, making it the "live end".

Sound travels from the speakers to the mixer's position and then reflects off the back wall and travels past the mix position again and is absorbed in the soft surfaces of the dead end. The key to the LEDE design is to time-delay or diffuse the returning wave, so that no standing wave patterns are created. Doing this successfully means that the recording engineer hears what's actually being recorded.
LEDE RoomJack FMISDN CodecsBlues HarmonicaStereo RecordingZero Crossing and DC OffsetPitch InflationGuitar TechsDigital DelayVocoderNashville Number System_RevisedThe First Radio Commerical
MrAudioSoundImages |

LEDE Room

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER