Uploaded December 2020 | Updated November 2026, 2 hours ago
I wanted to use my Mostly Printed CNC (MPCNC) to make a cool looking Christmas Decoration. So I decide to make one that can be light up with a nice Christmas engraving on it. I used my MPCNC to make the acrylic disc (600‘000 lines of code) and my 3D Printer to make the outer rings. I'm very pleased how it turned out.
ISBI
Homepage : isimplybuiltit.com
----------------------------------------------------------------------------------------------------------------
If you want to support my YouTube-Channel you can donate here :
paypal.me/isimplybuiltit
----------------------------------------------------------------------------------------------------------------
FOLLOW ME ON
INSTAGRAMM :
instagram.com/i_simply_built_it
TWITTER :
twitter.com/ISIMPLYBUILTIT
PINTEREST
https://www.pinterest.ch/isimplybuiltit/
FACEBOOK :
facebook.com/ISIMPLYBUILTIT
-------------------------------------------------------------------------------
#ISimplyBuiltIt #like #comment
-------------------------------------------------------------------------------
DON'T TRY THIS AT HOME :
I am a do-it-yourselfer and this is a private hobby video,
by showing me how to solve special tasks! The video is not an
instructional video and is not intended to be imitated!
That's why : All information and tips without guarantee!
Everyone is responsible for his actions and is responsible
for his own mistakes! For all work, the general observe
occupational health and safety regulations! I do not assume
any liability for damages and injuries!
I wanted to use my Mostly Printed CNC (MPCNC) to make a cool looking Christmas Decoration. So I decide to make one that can be light up with a nice Christmas engraving on it. I used my MPCNC to make the acrylic disc (600‘000 lines of code) and my 3D Printer to make the outer rings. I'm very pleased how it turned out.
ISBI
Homepage : isimplybuiltit.com
----------------------------------------------------------------------------------------------------------------
If you want to support my YouTube-Channel you can donate here :
paypal.me/isimplybuiltit
----------------------------------------------------------------------------------------------------------------
FOLLOW ME ON
INSTAGRAMM :
instagram.com/i_simply_built_it
TWITTER :
twitter.com/ISIMPLYBUILTIT
https://www.pinterest.ch/isimplybuiltit/
FACEBOOK :
facebook.com/ISIMPLYBUILTIT
-------------------------------------------------------------------------------
#ISimplyBuiltIt #like #comment
-------------------------------------------------------------------------------
DON'T TRY THIS AT HOME :
I am a do-it-yourselfer and this is a private hobby video,
by showing me how to solve special tasks! The video is not an
instructional video and is not intended to be imitated!
That's why : All information and tips without guarantee!
Everyone is responsible for his actions and is responsible
for his own mistakes! For all work, the general observe
occupational health and safety regulations! I do not assume
any liability for damages and injuries!





![How to Make a Table Saw Dust Hood
Since i work with my homemade table saw, the dust was always thrown back at me. So therefore i need a solution.
ISBI
#ISimplyBuiltIt
Music by : Kontinuum - Aware [NCS Release]
https://www.youtube.com/watch?v=BWdZjZV6bEk
▽ Follow Kontinuum
SoundCloud https://soundcloud.com/kontinuum
Facebook https://www.facebook.com/itsKontinuum
Twitter https://twitter.com/itsKontinuum How to Make a Table Saw Dust Hood](https://i.ytimg.com/vi/TkYoLxlHAD0/mqdefault.jpg)




