Uploaded June 2024 | Updated November 2026, 5 days ago
My lathe use to this point has been objects four inches in diameter or less on small micro lathes. I purchased a 10" x 18" lathe and attempted to turn a piece that was just under 7" x 4" and ran into all kinds of issues. So i did what i normally do, spent days and days watching YT videos to solve the problem. When i first put the piece on a face plate, attached it to the head stock and attempted to turn it, i heard a loud crack and immediately shut off the lathe, i discovered a crack had occurred in the wood and i knew something was wrong. i saw a video that said basically: anything bigger than 6" should be turned at about 750 rpm, and my lathe was running somewhere around 1600? speed was factory set. So this is about the journey to learn how to turn a 'larger' piece of wood, spalted maple in this case, on a larger lathe. I realize a 7" x 4" inches is not 'large' ,, but having only done my previous biggest piece of 4" x 4 inches ....it was a whole new ballgame.
My lathe use to this point has been objects four inches in diameter or less on small micro lathes. I purchased a 10" x 18" lathe and attempted to turn a piece that was just under 7" x 4" and ran into all kinds of issues. So i did what i normally do, spent days and days watching YT videos to solve the problem. When i first put the piece on a face plate, attached it to the head stock and attempted to turn it, i heard a loud crack and immediately shut off the lathe, i discovered a crack had occurred in the wood and i knew something was wrong. i saw a video that said basically: anything bigger than 6" should be turned at about 750 rpm, and my lathe was running somewhere around 1600? speed was factory set. So this is about the journey to learn how to turn a 'larger' piece of wood, spalted maple in this case, on a larger lathe. I realize a 7" x 4" inches is not 'large' ,, but having only done my previous biggest piece of 4" x 4 inches ....it was a whole new ballgame.










