Gregs Maker Corner | LDO Voron 0.1 Kit Electronics Wiring @GregsMakerCorner | Uploaded February 2022 | Updated October 2024, 2 hours ago.
DISCLAIMER: DOUBLE CHECK ALL WIRING BEFORE PLUGGING IN, AND CONSULT A LICENSED ELECTRICIAN IF YOU ARE NOT FAMILIAR WITH ELECTRONICS/ELECTRICAL WIRING. I AM NOT RESPONSIBLE IF YOU WIRE YOUR PRINTER INCORRECTLY.

This video follows my previous videos in the LDO build series. I go through the process for mounting the LDO Voron 0.1 kit components and wiring things up. Refer to this link for a guide on steps:

docs.ldomotors.com/en/voron/voron01/wiring_guide_rev_a

Before you go to do your first print, there are a number of configuration steps you will need to take, including installing and configuring Klipper.

Please refer to the following video:
youtube.com/watch?v=Viq8CWHG_Bg

Please review the pre-flight checks as listed here:
docs.vorondesign.com/build/startup

As always, thanks for watching!