LAGUNA 6 - Programming and Testing @Askjerry
LAGUNA 6 - Programming and Testing  @Askjerry
Uploaded February 2023 | Updated November 2026, 3 hours ago
The unit is programmed, we build a new control panel, and finally, we have to run the machine and actually cut material to test it out.

If you don't want to watch the whole thing, or you just want to see a section over again, just use the menu below.

00:14 - Gimp Photo Editing
02:53 - Inkscape Button Creation
04:22 - Example pyVCP code
04:31 - Showing the pyvcp Panel
06:06 - Testing the machine
07:51 - Homing the machine
09:47 - Starting a test cut
11:12 - Running the job at a deeper cut
12:49 - Closeup of the finished cut
13:07 - Electronics Layout
LAGUNA 6 - Programming and TestingJaberwoky   By Lewis Caroll Writen 1871Using VRCHAT for a Cinematic VideoTree Trimming July 14th 2023August 2017 Update and Check in...Monster Mill - 06 Probe Routines #4 - Installing the Glade PanelRobot Group Meeting 2021-07-15Birthday Call from Africa - June 12, 2021Solar Eclipse   August 21, 2017LAGUNA 8 - Joy of MovementMonster Mill - 09 Joystick and Buttons #2Mind in a Cage   by Riley Cassel
Askjerry |

LAGUNA 6 - Programming and Testing

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER